North Dakota NDDOT CDL General Knowledge Practice Test 5
Test 5 of 5. Pick an answer for each question to see if it is right and why; your score appears at the end. You need 40 correct answers to pass, the same ratio as the real North Dakota test.
- Questions50
- Correct to pass40
- Passing score80%
- Minimum age18 years
-
1. At a stop on a hot day you find a tire that is too hot to touch. What should you do?
Show answer
Answer C: Wait until the tire cools before driving on, and do not let air out of it
A tire that is too hot to touch may be about to fail or catch fire; releasing air only leaves it underinflated once it cools, which makes things worse.
-
2. Why should you never back under a trailer whose landing gear is resting on soft or muddy ground?
Show answer
Answer C: The landing gear can sink or collapse and the trailer can drop or tip over
Soft ground lets the landing gear sink under the load being transferred to it, and a trailer that drops or topples during coupling is extremely dangerous.
-
3. Your speedometer stops working during the pre-trip check. How should it be treated?
Show answer
Answer D: As a defect, because the driver cannot judge and control speed without it
A working speedometer is required equipment, because judging speed by feel in a heavy vehicle is unreliable and speed governs stopping distance.
-
4. Why does a load of hanging meat in a refrigerated trailer require special care in curves?
Show answer
Answer D: The meat swings and has a high center of gravity, which makes the trailer unstable
Hanging meat is heavy, sits high and swings, so the trailer can tip in a curve or on a ramp taken at normal speed.
-
5. What does the working load limit stamped on a chain or strap describe?
Show answer
Answer B: The maximum load the device is rated to hold in normal use
The working load limit is the rated safe capacity for everyday use, deliberately set well below the force that would break the device.
-
6. What is a bulkhead in a cargo body used for?
Show answer
Answer D: To divide the space and stop cargo from moving into another part of the body
A bulkhead is a solid partition that separates one part of the load space from another and blocks the cargo from moving past it.
-
7. A strap runs from an anchor point on one side of the trailer, over the load, and down to an anchor point on the opposite side. How much of its working load limit counts toward the total required?
Show answer
Answer C: All of it
A tiedown that is anchored on one side, passes over or around the cargo and is anchored on the other side counts its full working load limit toward the aggregate figure.
-
8. What does safe practice require of a commercial driver who wants to eat, drink or read a delivery note?
Show answer
Answer B: Handle it before or after driving, not while moving
Anything that takes hands, eyes or attention away from the task belongs outside the driving time, not inside it.
-
9. Besides staying secure, cargo carried inside a vehicle must not do what?
Show answer
Answer C: Block the driver view or access to emergency equipment and exits
Cargo may not obstruct the view to the front or sides or prevent the driver from reaching emergency equipment and exits.
-
10. Why is a leaking exhaust system on a commercial vehicle dangerous to the driver?
Show answer
Answer B: It can let carbon monoxide reach the cab, where it can poison the occupants
Exhaust gas contains carbon monoxide, which has no smell and dulls the driver judgment long before it becomes obvious that anything is wrong.
-
11. How do you get more engine braking from an automatic transmission on a downgrade?
Show answer
Answer B: Select a lower range before starting down
Locking the transmission into a lower range keeps engine speed high enough to hold the vehicle back and spares the service brakes.
-
12. What does the tachometer on the dashboard of a heavy truck show?
Show answer
Answer D: How fast the engine is turning, in revolutions per minute
The tachometer reads engine speed in rpm, which is what a driver uses to judge shift points in a vehicle with a manual transmission.
-
13. What is axle weight?
Show answer
Answer C: The weight carried to the ground by one axle or one set of axles
Axle weight describes how the load is shared among the axles that carry it to the road, not how much the whole vehicle weighs.
-
14. Within what distance should high beams be lowered at night?
Show answer
Answer D: Within about 500 feet of an oncoming vehicle and within about 500 feet of a vehicle you are following
High beams blind other drivers at close range, so they are lowered at roughly the same distance whether the other vehicle is coming toward you or is ahead of you.
-
15. What does the gross vehicle weight rating of a vehicle describe?
Show answer
Answer A: The maximum loaded weight of that single vehicle, as specified by the manufacturer
The rating is the manufacturer figure for the loaded weight of one vehicle, so it is a limit fixed in advance rather than a measurement of the load on board today.
-
16. Why does a heavy vehicle need a much larger gap than a car in order to cross or enter traffic?
Show answer
Answer C: Because it accelerates slowly and needs far more road and time to clear the intersection
Slow acceleration combined with the length of the vehicle means a gap that would feel comfortable in a car is nowhere near enough.
-
17. Where should a trailer be dropped, and what else does the driver do before pulling out from under it?
Show answer
Answer C: On solid level ground, with the trailer wheels chocked if it may roll
A dropped trailer must sit on ground that will carry the landing gear without sinking, and chocks stop it rolling once the tractor and its air supply are gone.
-
18. How is a shipping container normally secured when it is carried on a special container chassis?
Show answer
Answer B: With its own locking devices that attach the container directly to the chassis frame
Containers built for rail or ship transport have locking corners that fasten to a matching chassis; a container carried on a plain flatbed must be secured like any other cargo.
-
19. For an unblocked article longer than 10 feet, the minimum is two tiedowns plus how many more?
Show answer
Answer B: One more for every additional 10 feet of length or any part of 10 feet
Past the first 10 feet, one more tiedown is added for each additional 10 feet of length or any fraction of that distance.
-
20. You are about to slow down sharply on a highway to make a turn into a narrow driveway. How can you warn the drivers behind you?
Show answer
Answer C: Tap the brake pedal a few times so the brake lights flash before you slow down
A few light taps flash the brake lights and give following drivers an early warning that you are about to slow or stop.
-
21. A straight truck has a long body behind the rear axle. What happens to that overhang in a sharp left turn?
Show answer
Answer D: It swings out to the right and can strike a vehicle or an object on that side
Body that hangs behind the rear axle swings the opposite way to the turn, so the tail of the truck sweeps out into the next lane or over the curb.
-
22. Under the federal air brake standard, the low air pressure warning must come on before reservoir pressure drops below what level?
Show answer
Answer A: Before pressure falls below 60 psi
Federal Motor Vehicle Safety Standard 121 requires the warning to operate while service reservoir pressure is still above 60 psi, which leaves enough air to bring the vehicle to a normal stop.
-
23. A load overhangs the rear of the trailer. What must the driver check before leaving?
Show answer
Answer D: That the overhang is marked as required, with flags or lamps as conditions demand
A projecting load has to be made visible to other drivers, with flags in daylight and lamps when lights are required, so nobody runs into what they cannot see.
-
24. Total stopping distance is made up of which parts?
Show answer
Answer A: Perception distance, reaction distance and braking distance
The vehicle travels while the hazard is recognized, while the driver moves to the pedal, and again while the brakes slow the vehicle.
-
25. At the end of the day you find no defects on a property carrying vehicle. What does the federal rule require?
Show answer
Answer B: No written report is required, although the carrier may still ask for one
For property carrying vehicles the report is required only when a defect or deficiency is found or reported, although a carrier may impose a stricter policy.
-
26. You are the first to arrive at a crash. What is the correct order of actions?
Show answer
Answer C: Protect the area, notify the authorities, care for the injured
Preventing a second crash comes first, because an unprotected scene puts the injured and the helpers in more danger than the original collision.
-
27. Besides the hours when the law requires them, when should headlights be switched on?
Show answer
Answer A: Any time visibility is poor, such as in rain, fog or at dusk
Headlights are used to be seen as much as to see, so they belong on whenever light or weather makes the vehicle harder to spot.
-
28. During the vehicle overview, what should the driver look for on the ground under the vehicle?
Show answer
Answer B: Fresh puddles of oil, coolant, grease or fuel
New stains on the ground are the earliest sign of a leak, so the overview includes a look underneath before anything is opened or started.
-
29. How are the extra gears of a multi-speed rear axle or auxiliary transmission usually controlled?
Show answer
Answer D: With a selector knob or switch on the gearshift lever of the main transmission
A range selector on the shift lever lets the driver choose the extra gear range while shifting the main transmission.
-
30. A driver snores heavily, stops breathing briefly during the night and is tired all day despite long hours in bed. What should be suspected?
Show answer
Answer B: Sleep apnea
Sleep apnea repeatedly interrupts breathing during sleep, so the driver never gets true rest and stays dangerously drowsy during the day.
-
31. Why should both outside mirrors be checked over and over while backing?
Show answer
Answer B: Each mirror covers only part of the path and neither covers the blind spots, so people and objects can appear without warning
Working both mirrors in turn is the only way to follow the whole path of a vehicle you cannot see behind.
-
32. What should you check about the air hoses and the electrical cord running to the trailer?
Show answer
Answer D: That they are free of damage, properly connected and not dragging or rubbing
Lines that chafe on the frame or drag on the road wear through, and a broken line takes away trailer braking or trailer lighting without warning.
-
33. What is the driver responsible for when a load is covered with a tarp?
Show answer
Answer C: Fastening it so it cannot flap free, block a mirror, or come off in the wind
A tarp that works loose can tear away, block the driver view or the view of others, and become a hazard for the traffic behind.
-
34. What is the first step of the standard seven-step vehicle inspection?
Show answer
Answer C: A general overview of the vehicle, including the last inspection report
The routine opens with a walk-up overview of the vehicle and a review of the previous inspection report so known defects are addressed first.
-
35. A roadside test shows a commercial driver has measurable alcohol in the system but below 0.04. What happens?
Show answer
Answer C: The driver is placed out of service for 24 hours
Any measurable alcohol while on duty results in an immediate 24 hour out of service order, even when the concentration is under the 0.04 limit.
-
36. You are unsure whether your vehicle will fit through a narrow gate. What should you do?
Show answer
Answer A: Stop, get out and look, and take another route if the space is not clearly enough
Clearance is never guessed at from the seat; you look at it on foot and go round rather than trying a gap that may be too tight.
-
37. Why should a large vehicle be accelerated smoothly and gradually?
Show answer
Answer A: Rough acceleration can damage the drivetrain and, on a combination, the coupling
Jerky throttle inputs put shock loads through the driveline and the coupling, which causes mechanical damage over time.
-
38. When should a lower gear be selected for a long downgrade?
Show answer
Answer D: Before you start down the hill
The gear is chosen at the top, while speed is still low, because a heavy vehicle already rolling fast may not go into a lower gear at all.
-
39. A dispatcher tells you to take a trailer you believe is loaded badly enough to be unsafe. What should you do?
Show answer
Answer C: Refuse to move it until the load has been made safe
The driver may not operate a vehicle whose cargo is not properly distributed and secured, and an instruction from an employer does not change that.
-
40. Federal rules forbid operating a commercial vehicle in which condition?
Show answer
Answer C: In a condition likely to cause a crash or a breakdown
A defect that makes a crash or a breakdown likely has to be corrected before the vehicle is driven, not reported at the end of the trip.
-
41. The engine has overheated and you need to check the coolant. What is the safe procedure with a pressurized radiator cap?
Show answer
Answer A: Shut the engine off, let the system cool, protect your hands, turn the cap slowly to its first stop so pressure escapes, step back, then remove it
A hot pressurized system throws steam and boiling coolant out of the opening, so the pressure is released slowly and only after the engine has cooled.
-
42. Within total stopping distance, what exactly is perception distance?
Show answer
Answer D: The distance traveled from the moment your eyes see a hazard until your brain identifies it
Perception distance covers only the time between seeing a hazard and recognizing it as a hazard, before any physical reaction begins.
-
43. Which document must be available to show that the annual inspection was carried out?
Show answer
Answer C: The inspection report or a copy of it, or a decal displayed on the vehicle
Proof of the periodic inspection travels with the vehicle, either as the report itself or as the decal fixed where an inspector can see it.
-
44. Why is a quick lane change particularly risky with a load of hanging meat or of livestock?
Show answer
Answer A: The load swings or leans and can keep pushing the trailer after you straighten out
A swinging or leaning load keeps moving after the vehicle has finished the maneuver, so its momentum acts on the trailer at the worst moment.
-
45. What is checked about the clutch and the gearshift during the in-cab inspection?
Show answer
Answer D: That the clutch free play is within the range the manufacturer specifies
Too little or too much clutch free play causes slipping or dragging, either of which can leave the driver unable to select the gear a hill demands.
-
46. What are you looking for when you check the drive belts in the engine compartment?
Show answer
Answer C: That each belt is snug and free of cracks, frays or heavy wear
A loose or cracked belt can break and stop the fan, the water pump or the alternator, which leads quickly to overheating or a dead electrical system.
-
47. Besides slowing down, which technique most reduces the risk of a skid on a snow covered road?
Show answer
Answer B: Make every steering, braking and speed change gradual
Traction is limited on snow, and sudden inputs demand more grip than the surface can supply, so smoothness is what keeps the tires attached to the road.
-
48. On a wet road, a commercial driver should reduce speed by roughly how much?
Show answer
Answer C: By about one third
Cutting speed by roughly a third, for example from 55 to about 35 mph, restores a margin for the traction lost on a wet surface.
-
49. What makes a brake hose or air line a defect during the walkaround?
Show answer
Answer D: It is cracked, worn, kinked, or rubbing against another part
A chafed or cracked line can burst under pressure and take the braking on that circuit with it, so damage and rubbing points must be corrected.
-
50. How do you avoid the sharp lurch that comes at the very end of a stop in a heavy vehicle?
Show answer
Answer A: Ease off the brake pressure just before the vehicle actually comes to rest
A smooth stop is finished by reducing pedal pressure as the vehicle settles, so the suspension does not rock the cab and the load forward.